Connecting Vhf And Uhf Antennas; Antennas With 300-Ohm Flat Twin Leads - Samsung HC-R4745W Owner's Instructions Manual

C h a p t e r Tw o
I
N S TA L L AT I O N

Connecting VHF and UHF Antennas

If your antenna has a set of leads that
look like this, see "Antennas with
300-ohm Flat Twin Leads," below.
If your antenna has one lead that looks
like this, see "Antennas with 75-ohm
Round Leads," on page 15.
If you have two antennas, see "Separate
VHF and UHF Antennas," on page 15.

Antennas with 300-ohm Flat Twin Leads

If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has 300-
ohm twin flat leads, follow the directions below.
1
Place the wires from the
twin leads under the screws
on the 300-75 ohm adaptor
(not supplied). Use a
screwdriver to tighten the
screws.
2
Plug the adaptor into the
"ANT 1 IN (Air)" terminal on
the rear panel.
English - 14