Supported Operating Systems; Using Setip Program - Samsung CLP-350 User Manual

Supported operating systems

The following table shows the network environments supported by the
machine:
Item
Network interface 10/100 Base-TX
Network operating Windows 2000/XP/Vista
system
Various Linux OS
Macintosh 10.3 ~ 10.5 (CLP-610 series)
Network protocols TCP/IP, DLC/LLC, IPP, SNMP
Dynamic addressing DHCP, BOOTP
server
Note
• SyncThru™ Web Admin Service: Web-based printer
management solution for network administrators. SyncThru™
Web Admin Service provides you with an efficient way of
manageing network devices and lets you remotely monitor and
troubleshoot network machines from any sith with corporate
internet access. Download this program from
solution.samsungprinter.com.
• SyncThru™ Web Service: A Web server embedded to your
network print server, which allows you to configure the network
parameters necessary for the printer to connect to various
network environments.
• SetIP: Utility program allowing you to select a network interface
and manually configure the IP addresses for use with the TCP/
IP protocol. See "Using SetIP program" on page 3.2.
Requirements
http://

Using SetIP program

This program is for the network IP setting using the MAC address which
is the hardware serial number of the network printer card or interface.
Especially, it is for the network administrator to set several network IPs at
the same time.
Insert the driver CD provided along with your machine.
1
Start Windows Explorer and open the X drive. (X represents your
2
CD-ROM drive.)
Double click Application > SetIP.
3
Open the language folder you want to use.
4
Double click Setup.exe to install this program.
5
From the Windows Start menu, select Programs > Samsung
6
Network Printer Utilities > SetIP.
Select the name of your printer and click "
7
Note
If you cannot find your printer name click "
the list.
Enter the network card's MAC address, IP address, subnet mask,
8
default gateway, and then click Apply.
Note
If you do not know the network card's MAC address, print
the machine's network information report.
Click OK to confirm the settings.
9
10 Click Exit to close the SetIP program.
Note
If you want to setup DHCP network protocol, go to the http://
developer.apple.com/networking/bonjour/download/, select the
program Bonjour for Windows due to your computer operating
system, and install the program. This program will allow you to
fix the network parameter automatically. Follow the instruction in
the installation window. This program does not support Linux.
3.2
<Getting Started>
".
" to refresh