Advertisement
Quick Links
Emergency backup power supply
Battery Replacement Instructions
GE Simon 3 System
Those residential security system have a backup battery designed to supply power to the security system during a limited
power outage. The battery must be replaced from time to time due to age and usage. The backup battery needs to be
replaced when the keypad displays a "BAT" or "SYSTEM LO BATTERY" message.
In most cases you can replace the battery yourself, typically saving you time and money. The process requires the removal
of two wires from the old battery and reconnecting the same wires to the new battery. Before replacing the battery, please
read instructions carefully, including the Battery Safety Warning instructions on page 2.
1 – Ensure you have your Personal Identification Code (PIC) and then call 800 653‐9111 to have your system
placed on test.
2 – Confirm you received the correct backup power supply from ADT. (Picture 1)
3 – Locate the panel's transformer and unplug. (Picture 2)
4 – Press the plastic tab located on top of the unit down and open up the front cover of the system keypad.
(Picture 3)
5 – Once the front cover is opened, press tab up with a flathead screwdriver and swing chassis down. (Picture 4)
6 – Remove 2 set screws and open up emergency backup power supply tray cover. (Picture 5)
7 – Remove old emergency backup power supply and replace with new emergency backup power supply.
(Picture 6)
8 – Close emergency backup power supply tray cover; re‐install 2 screws; and close chassis. Close the front
cover of the system keypad.
9 – Plug in the panel's transformer after 1 minute.
10 – Test system after replacing battery.
11 – Call 800 653‐9111 and request that the system be removed from test.
12 – Take your old emergency backup power supply to the nearest recycling centre.
©2017 ADT Canada Inc. All rights reserved. ADT, the ADT logo, and the names of products and services are ADT trademarks or registered
trademarks. Unauthorized use is strictly prohibited. Third party trademarks are property of the trademark owners.
Licence number: RBQ 5591‐1473‐01
Advertisement
Related Manuals for GE Simon 3
Summary of Contents for GE Simon 3
- Page 1 Emergency backup power supply Battery Replacement Instructions GE Simon 3 System Those residential security system have a backup battery designed to supply power to the security system during a limited power outage. The battery must be replaced from time to time due to age and usage. The backup battery needs to be replaced when the keypad displays a “BAT” or “SYSTEM LO BATTERY” message. In most cases you can replace the battery yourself, typically saving you time and money. The process requires the removal of two wires from the old battery and reconnecting the same wires to the new battery. Before replacing the battery, please read instructions carefully, including the Battery Safety Warning instructions on page 2. 1 – Ensure you have your Personal Identification Code (PIC) and then call 800 653‐9111 to have your system ...
- Page 2 Battery Safety Warning This section on Battery Safety should be read in its entirety and its contents understood before handling or using a rechargeable sealed lead‐acid battery. MSDS (Material Safety Data Sheets) are available upon request. • Due to the potential energy stored in a sealed lead‐acid battery, improper handling or use of the battery or failure to observe the precautions listed in this document may result in bodily injury caused by electrolyte leakage, heat generation or explosion. • USE ELECTRICALLY INSULATED TOOLS. Use of un‐insulated tools may cause a short circuit and the heat or sparks generated by the short circuit can result in burns, damage to the battery, or an explosion. Metallic tools may be insulated using vinyl or electrician’s tape. ...