Teac PR130 User Manual

2 BAND POCKET RADIO PLL
R-3745A IB TEAC 001 REV0.indd 1
PR130
LOCATION AND DESCRIPTION OF CONTROLS
1. LCD display
2. / Tuning/ setting
3. Volume UP
4. Volume down
5. Preset up
6. Preset down
7. Speaker
8. Memorization
Setting the clock
POWER SUPPLY
Choose one of the power sources as below.
• AC adapter (not included): Output DC 3V
• Batteries (not included): DC 3V
Connecting power
Connect an AC adapter (not supplied) to the DC IN 3V jack of the unit and to the mains socket.
Caution!
• Check that the voltage marked on the adapter rating plate matches your local supply.
• Never use an AC adaptor that is damaged, route power lead in a safe manner and make sure it is
not subjected to trapping or pinching. If the power lead is damaged refer to a qualified service agent.
• The AC adaptor is used as the disconnect device and it shall remain readily operable. To be completely
disconnected from the power input, the AC adaptor shall be disconnected from the mains completely.
The AC adaptor should not be obstructed and should be easily accessible during intended use.
Note:
- The AC adaptor must be unplugged from the power outlet for the unit to run on the batteries.
- When the set is connected to the mains, the power source automatically switches to AC.
Battery operation
1. Remove the lid of the battery compartment.
9. St./Mo.: Stereo/Mono selection
: key lock
10. Band selection (AM/FM)
Alarm / (Snooze)
11. To turn unit ON/OFF
: Sleep
12. DC IN 3V jack
13. Phones jack
14. Telescopic antenna
15. Battery compartment
300mA
2x1.5V R03/ UM-4/AAA
2017/6/26 13:49:08