Cisco Nexus 9000 Series Configuration Manual page 48

Configuration Examples for ITD
node ip 1.1.1.1
node ip 2.1.1.1
node ip 3.1.1.1
itd test
device-group dg1
ingress interface Eth1/11
load-balance method dst ip
access-list acl1
no shut
This example shows how to nondisruptively add an ACE to an include ACL:
switch(config)#
switch(config-acl)# ip access-list acl1
switch(config-acl)# 1010 permit tcp any 10.220.0.0/16
switch(config-acl)# 1020 permit tcp any 20.1.1.0/24
switch(config)# show ip access-lists acl1
IP access list acl1
switch(config)# itd device-group dg1
switch(config-device-group)#
switch(config-device-group)#
switch(config-dg-node)#
switch(config-dg-node)#
switch(config-dg-node)#
switch(config-dg-node)# itd test
switch(config-itd)#
switch(config-itd)#
switch(config-itd)#
Note: Configure buckets equal or more than the total number of nodes.
switch(config-itd)#
switch(config-itd)#
switch(config)# show run service
!Command: show running-config services
!Time: Tue Sep 20 20:44:17 2016
version 7.0(3)I5(1)
feature itd
itd device-group dg1
probe icmp
node ip 1.1.1.1
node ip 2.1.1.1
node ip 3.1.1.1
node ip 4.1.1.1
itd test
device-group dg1
ingress interface Eth1/11
load-balance method dst ip
access-list acl1
no shut
Cisco Nexus 9000 Series NX-OS Intelligent Traffic Director Configuration Guide, Release 9.x
40
1010 permit tcp any 10.220.0.0/16
1020 permit tcp any 20.1.1.0/24
probe icmp
node ip 1.1.1.1
node ip 2.1.1.1
node ip 3.1.1.1
node ip 4.1.1.1
device-group dg1
ingress interface Eth1/11
load-balance method dst ip
access-list acl1
no shut
Configuring ITD