Setting The Speaker Mode; Setting The Test Tone - Samsung HT-P29 Instruction Manual

Setting the Speaker Mode

Signal outputs and frequency responses from the speakers will automatically be adjusted according to your
speaker configuration and whether certain speakers are used or not.
Press Cursor
In Stop mode,
1 2
button to move to
press MENU
'Audio' and then
button.
press ENTER button.
Press Cursor
In the Speaker
3 4 , buttons to move
Setup, press the
to the desired
speaker and then
ENTER button again.
press ENTER button.
•
For C, LS, and RS, each time the button
is pressed, the mode switches
alternately as follows: SMALL
•
For L and R, the mode is set to SMALL.
SMALL : Select this when using the speakers.
NONE : Select this when no speakers are connected.
Note
•
Depending on PRO LOGIC and STEREO settings, the speaker mode may vary (see page 55).
47
, ,
NONE.

Setting the Test Tone

Use the Test Tone feature to check the speaker connections.
In Stop or no
1 2
disc mode,
press MENU
button.
Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen.
Alternate method: press the TEST TONE button on the remote.
Press TEST TONE button.
•
Test tone will be produced as follows:
When playing a DVD or CD, this will work
only in Stop mode.
•
Use this function to check that each speaker is
correctly connected and that there is no problem.
To end the test tone,
press TEST TONE button again.
Press Cursor Press Cursor
3
button to move to to move to 'TEST
'Audio' and then TONE' and then press
press ENTER button. ENTER button.
•
The test tone will be sent to L
R RS LS SW in order.
If the ENTER button is pressed again
at this time, the test tone will stop.
L: Front Speaker (L) C: Center Speaker
R: Front Speaker (R) LS: Rear Speaker (L)
Multi-Channel Pro Logic Mode
Start
ENG
button
C
SW: Subwoofer
RS: Rear Speaker (R)
48