DISMANTLING INSTRUCTIONS
Dismantling of the Front Panel assembly
1) Loosen & remove 4 screws A (see figure 1).
2) Place a small flat screw driver in between the front & rear
cabinets and roll the screw driver along the joint as shown
in figure 2.
3) Release total 6 catches on left and right side of rear
cabinet to separate it from the rear assembly.
2-1
Figure 1
Figure 2
Dismantling of the PCB assemblies and modules
1) Loosen 4 screws B to remove DVD Loader as shown in
Figure 3.
2) Loosen 2 screws C and 7 screws D to remove the Display
Board as shown in Figure 4.
Figure 4
4) Loosen 2 screws F and 4 screws G and 2 screws H to
remove Swing System as shown in Figure 5.
2-1
Figure 3
3) Loosen 2 screws E to remove the AMP Key Board as
shown in Figure 4.
Figure 5