Memorizing The Channels - Samsung SPN4235 Owner's Instructions Manual

Memorizing the Channels

Your PDP can memorize and store all of the available channels for both "off-air" (antenna)
and cable channels. After the available channels are memorized, use the CH
buttons to scan through the channels. This eliminates the need to change channels by entering
the channel digits. There are three steps for memorizing channels: selecting a broadcast
source, memorizing the channels (automatic) and adding and deleting channels (manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type of
signal source that is connected to the PDP (i.e., an antenna or a cable system).
Press the MENU button. Press the UP or DOWN
1
button to select "Channel", then press the ENTER
button.
Press the LEFT or RIGHT button to select "Ant",
2
"STD", "HRC" or "IRC".
• If you are connected to an antenna, leave "Ant"
displayed. If you connected cable, press the
LEFT or RIGHT button to the display the type of
cable system: "STD", "HRC", or "IRC".
(If you are not sure which type of cable system you
have, contact your cable company).
Press the MENU button to exit.
3
Note
• STD, HRC and IRC identify various types of cable TV systems. Contact your local cable company
to identify the type of cable system that exists in your particular area.
At this point the signal source has been selected. Proceed to "Storing Channels in Memory"
(next page).
32
and CH
Channel
Ant/ CATV Ant
Auto Program
Fine Tune 0
LNA Off
Ch. Scan
Move Select Menu
Channel
Ant/ CATV STD
Auto Program
Fine Tune 0
LNA Off
Ch. Scan
Move Select Menu
Storing Channels in Memory (Automatic Method)
First, select the correct signal source (Ant, STD, HRC,
1
IRC). See steps on previous page.
Press the MENU button. Press the UP or DOWN button
to select "Channel", then press the ENTER button.
Quick way to access the Automatic Channel Setting : Just press the
"AUTO PROG." button on the remote control.
Press the UP or DOWN button to select "Auto Pro-
2
gram", then press the ENTER button.
The PDP will begin memorizing all of the available
3
channels.
After all the available channels are stored, the
Auto program menu reappears. Press the RIGHT
button to stop.
Note
• The PDP automatically cycles through all of the available channels and stores them in memory.
This takes about one to two minutes.
Channel
Ant/ CATV Ant
Auto Program
Fine Tune 0
LNA Off
Ch. Scan
Move Select Menu
Channel
Ant / CATV Ant
Auto Program
Fine Tune 0
LNA Off
Ch. Scan
Move Enter Menu
Ant 50
Auto Program
: Stop
33