Memorizing The Channels; Adding And Erasing Channels - Samsung HLP4663W Instruction Manual

Operation

Memorizing the Channels

Your TV can memorize and store all of the available channels for both "off-air" (antenna) and
cable channels. After the available channels are memorized, use the CH
scan through the channels. This eliminates the need to change channels by entering the channel
digits. There are three steps for memorizing channels: selecting a broadcast source, memorizing
the channels (automatic) and adding/deleting channels (manual).
Selecting the Video Signal Source
Before your TV can begin memorizing the available channels, you
must specify the type of signal source that is connected to the TV
(i.e., an antenna or a cable system).
1
Press the MENU button.
Press the ... or † button to
select "Channel", then press
the ENTER button.
2 Press the ... or † button to
select "Air/CATV", then
press the ENTER button.
If you are connected to an
antenna, press the ... or †
button to select "Air".
If you connected cable,
press the ... or † button to
select the type of cable
system: "STD", "HRC" or
"IRC".
Press the EXIT button to exit.
NOTES
• "STD", "HRC" and "IRC" identify various types of cable TV
systems. Contact your local cable company to identify the type
of cable system that exists in your particular area. At this point
the signal source has been selected. Proceed to "Storing
Channels in Memory".
• Subscription cable services require service-specific requirement
for viewing.
28
and CH buttons to
Channel
Antenna : Ant.1 √
Input
Air/CATV : Air √
Auto Program √
Picture
Add/Delete √
√
Sound Favorite Channels
√
Name
√
Channel Fine Tune
M More
Setup
Move Enter Return
Channel
Antenna : Ant.1 Air
Input
Air/CATV : Air STD
Auto Program HRC
Picture
IRC
Add/Delete
Sound Favorite Channels
Name
Channel Fine Tune
M More
Setup
Move Enter Return
Storing Channels in Memory (Automatic Method)
First, select the correct signal source ("Air", "STD", "HRC" or "IRC") as
described on the previous page.
1
Press the MENU button.
Press the ... or † button to select
"Channel", then press the ENTER button.
Picture
Sound
Channel
2 Press the ... or † button to select "Auto
Program", then press the ENTER button.
Press the ENTER button to start the auto
program.
The TV begins memorizing all of the
available stations.
Press the ENTER button at any time to
interrupt the memorization process.
Press the EXIT button to exit.

Adding and Erasing Channels

To add channels that were not memorized (or to delete unwanted channels from
memory):
1
Press the MENU button.
Press the ... or † button to select
"Channel", then press the ENTER button.
Picture
Sound
Quick way to access Add/Delete: Just
Channel
press the ADD/DEL button on the remote
control.
2 Press the ... or † button to select
"Add/Delete", then press the ENTER
button.
Repeatedly pressing the ENTER button will
alternate between add channel and delete
channel.
Press the CH or CH button (or
number buttons) to switch to the
appropriate channel, then repeat above.
Press the EXIT button to exit.
Channel
Antenna : Ant.1 √
Input
Air/CATV : Air √
√
Auto Program
√
Add/Delete
√
Favorite Channels
√
Name
√
Fine Tune
M More
Setup
Move Enter Return
Auto Program
Start
Enter Return
Channel
√
Antenna : Ant.A
Input
√
Air/CATV : Air
√
Auto Program
√
Add/Delete
√
Favorite Channels
√
Name
√
Fine Tune
M More
Setup
Move Enter Return
Add/Delete
Air 12 Not In Memory
Add
Change Enter Return
29