Table of Contents
Advertisement
Installation
After checking the height, width, and structure of the installation location while referring to "Standard installation
dimensions" on pages 5 to 11, determine the appropriate positions for setting up the screen and installing the
projector.
To mount this product on an already installed ceiling mount bracket, refer to "Using an existing bracket" on pages
15 to 17.
Setting up the screen
Set up the screen according to the specified method in a position which takes into account the projection distance
and angle and the type of screen being used.
Screws tightening torques
M6...............
4±0.5 N•m
M8............... 10±1 N•m
M10............. 20±1 N•m
z Use a torque screwdriver or torque wrench to tighten screws and bolts to their specified tightening torques. Do
not use electric screwdrivers or impact screwdrivers.
Installing the bracket to the projector
Attach the projector mount bracket to the projector (sold separately).
PT-RZ670 / RW630
Secure in five places
12 - ENGLISH
ET-PKD130B_EN_TQZJ577-7.indd
12
PT-RZ670 / RW630 / RZ970 /
RW930 / RX110 / RZ770 /
RW730 / RZ660 / RW620
Projector mount bracket
< For the PT-RZ770 / RW730 / RZ660 / RW620 /
RZ970 / RW930 / RX110 / RZ670 / RW630>
1) Place the projector upside-down onto a piece of
soft material.
2) Turn the adjustment leg(s) (see the two points for
PT-RZ670 / RW630 or the one point for
PT-RZ970 / RW930 / RX110 / RZ770 / RW730 /
RZ660 / RW620 in the figure on the left) clockwise
to minimize the length of the legs.
z If the adjustment legs (see the two points in
the figure on the left) are too long, the projector
mount bracket will come into contact with the
legs, and mounting it onto the projector will not
be possible.
3) Firmly secure the projector mount bracket to the
bottom of the projector using the five supplied
captive washer hex head bolts (M6 × 16) as shown
in the figure on the left.
z Use five of the six captive washer head bolts
supplied with the unit.
2017/03/13
19:04:55
Advertisement
Table of Contents
