Connecting A Vcr; S-Video Connection - Samsung PN50A650TF Quick Setup Manual

Connecting a VCR

Video Connection
VCR Rear Panel
2

Audio Cable (Not supplied)
S-Video Cable (Not supplied)
Antenna Cable (Not supplied)
➢
If you have a "mono" (non-stereo) VCR, use a Y-connector (not supplied) to connect to the right and left audio input jacks of the
TV. Alternatively, connect the cable to the "R" jack. If your VCR is stereo, you must connect two cables.
➢ Each VCR has a different back panel configuration.
➢ When connecting a VCR, match the color of the connection terminal to the cable.
➢
When connecting to AV IN 1, the color of the AV IN 1 [Y/VIDEO] jack (Green) does not match the color of the video cable (Yellow).

S-Video Connection

VCR Rear Panel

Antenna Cable (Not supplied)
Audio Cable (Not supplied)
2
S-Video Cable (Not supplied)
An S-Video cable may be included with your VCR. (If not, check your local electronics store.)
➢ Each VCR has a different back panel configuration.
➢ When connecting a VCR, match the color of the connection terminal to the cable.
TV Rear Panel
TV Rear Panel
TV Side Panel
English - 5
1
TV Side Panel
2
3
4
5
6
1
2
3
4
Unplug the cable or antenna from
the back of the TV.
Connect the cable or antenna to the
ANT IN terminal on the back of the
VCR.
Connect an Antenna Cable between
the ANT OUT terminal on the VCR
and the ANT IN terminal on the TV.
Connect a Video Cable between the
VIDEO OUT jack on the VCR and
the AV IN 1 [Y/VIDEO] or AV IN 2
[VIDEO] jack on the TV.
Connect Audio Cables between the
AUDIO OUT jacks on the VCR and
the AV IN 1 (or AV IN 2)
[R-AUDIO-L] jacks on the TV.
Press the SOURCE button on the
remote control until you see the
VCR signal (see "To Select the
Source" on page 10).
To begin, follow steps 1–3 in the
previous section to connect the
antenna or cable to your VCR and
your TV.
Connect an S-Video cable between
the [S-VIDEO] jack on the TV and
the S-VIDEO OUT jack on the VCR.
Connect Audio Cables between the
AUDIO OUT jacks on the VCR and
the AV IN 2 [R-AUDIO-L] jacks on
the TV.
Press the SOURCE button on the
remote control until you see the
VCR signal (see "To Select the
Source" on page 10).