Connecting A Vcr; Connecting An Amplifier / Dvd Home Theater - Samsung PN50A510P3F Quick Setup Manual

Connecting a VCR

VCR Rear Panel
Audio Cable
(Not supplied)
Video Cable (Not supplied)
Antenna Cable (Not supplied)
➢ If you have a "mono" (non-stereo) VCR, use a Y-connector (not supplied) to hook up to the right and left audio input jacks of the
TV. If your VCR is stereo, you must connect two cables.
➢ Each VCR has a different back panel configuration.
➢ When connecting a VCR, match the color of the connection terminal to the cable.
➢
When connecting to AV IN, the color of the AV IN [Y/VIDEO] jack (Green) does not match the color of the video cable (Yellow).

Connecting an Amplifier / DVD Home Theater

Amplifier / DVD Home Theater
Audio Cable (Not supplied)
TV Rear Panel
2 
TV Rear Panel

English - 5
1
Unplug the cable or antenna from
the back of the TV.
2
Connect the cable or antenna to the
ANT IN terminal on the back of the
VCR.
3
Connect an Antenna Cable between
the ANT OUT terminal on the VCR
and the ANT IN terminal on the TV.
4
Connect a Video Cable between the
VIDEO OUT jack on the VCR and
the AV IN [Y/VIDEO] jack on the TV.
5
Connect Audio Cables between the
AUDIO OUT jacks on the VCR and
the AV IN [R-AUDIO-L] jacks on the
TV.
6
Press the SOURCE button on
the remote control until you see
the VCR signal (see "Viewing an
External Signal Source" on page 9).
1
Connect Audio Cables between the
AUDIO OUT [R-AUDIO-L] jacks on
the TV and AUDIO IN [L-AUDIO-R]
jacks on the Amplifier/DVD Home
Theater.
When an audio amplifier is
connected to the AUDIO OUT
[R-AUDIO-L] jacks terminals :
Decrease the volume of the TV,
and adjust the volume level with the
Amplifier's volume control.
➢ Each Amplifier / DVD Home
Theater has a different back panel
configuration.
➢ When connecting an Amplifier / DVD
Home Theater, match the color of the
connection terminal to the cable.