Installing Batteries In The Remote Control; Switching On And Off; Placing Your Television In Standby Mode; Plug & Play - Samsung LW15M2 Owner's Instructions Manual

Installing Batteries in the Remote Control

1.
2.
3.

Switching On and Off

The mains lead is attached to the rear of your set.
1. Plug the mains lead into an appropriate socket.
The standby indicator lights up on the lower-right panel.
2. Press the POWER
The programme that you were watching last is reselected automatically.
3. Press the numeric button (0~9) or channel up/down (
button on the lower-right panel.
When you switch the set on for the very first time, you will be asked to choose language in which the menus
are to be displayed.
4. To switch your set off, press the POWER

Placing Your Television in Standby Mode

Your set can be placed in standby mode in order to reduce the power consumption. The standby mode
can be useful when you wish to interrupt viewing temporarily (during a meal, for example).
1. Press the POWER
The screen is turned off and a standby indicator appears on the lower-right panel.
2. To switch your set back on, simply press the POWER
up/down ( / ) button again.
Do not leave your set in standby mode for long periods of time (when you are away on holiday, for example).
It is best to unplug the set from the mains and aerial.
Plug & Play
Slide the cover out completely.
Install two AAA size batteries.
Make sure to match the "+" and "–" ends of the batteries with the diagram inside the compartment.
Replace the cover.
Remove the batteries and store them in a cool, dry place if you won't be using the
remote control for a long time. The remote control can be used up to about 23 feet from
the TV. (Assuming typical TV usage, the batteries last for about one year.)
If the remote control doesn't work, check the following:
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power outage, or is the power cord unplugged?
5. Is there a special fluorescent light or neon sign nearby?
button on the lower-right panel.
button on the remote control.
When the TV is initially powered on, several basic settings proceed
automatically and subsequently. The following settings are available.
1. Press the POWER
The message "Start Plug & Play" is displayed with "OK" selected.
2. Select the appropriate language by pressing the
Press the ENTER
3. The message "Check antenna input." is displayed with "OK" selected.
Press the ENTER
Please check that the antenna cable is connected correctly.
/ ) button on the remote control or
button again.
, numeric buttons (0~9) or channel
button on the remote control.
button to confirm your choice.
button.
English-6
or button.