Chapter 2: Installation; Connecting Vhf And Uhf Antennas; Antennas With 300-Ohm Flat Twin Leads - Samsung LTN226W Manual

06.CHAPTER2_EN 9/2/03 3:24 AM
2
C h a p t e r Tw o
I
N S TA L L AT I O N

Connecting VHF and UHF Antennas

If your antenna has a set of leads that
look like this, see "Antennas with
300-ohm Flat Twin Leads", below.
If your antenna has one lead that looks
like this, see "Antennas with 75-ohm
Round Leads", on page 7.
If you have two antennas, see "Separate
VHF and UHF Antennas", on page 7.

Antennas with 300-ohm Flat Twin Leads

If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has
300-ohm twin flat leads, follow the directions below.
Page 6
1
Place the wires from
the twin leads under
the screws on a 300-
75 ohm adaptor (not
supplied). Use a
screwdriver to tighten
the screws.
2
Plug the adaptor into
the TV ANTENNA
terminal on the
bottom of the back
panel.
6
English-