Husqvarna 131RB Operator's Manual page 11

To install the transport guard
1. Attach the transport guards on the blade.
To adjust the harness
WARNING: The product must always be
correctly attached to the harness. Do not
use a defective harness.
1. Put on the harness.
2. Adjust the harness for the best work position.
3. Adjust the side straps until the weight is the same
across your shoulders.
4. Adjust the harness until the cutting attachment is
parallel to the ground.
5. Let the cutting attachment stay lightly on the ground.
And then adjust the harness clamp to balance the
product correctly.
Note: If you use a grass blade, it must balance
approximately 10 cm (4 in) above the ground to keep
the grass blade from hitting the ground.
537 - 005 - 23.05.2018
To install the liner
1. Remove the bolt (A) on the joint (B) of the outer pipe.
A
C
2. Align the groove (C) of the liner with the thread hole
and tighten the screw.
3. Turn the flexible shaft (D) at the opposite end from
the liner (E) to install it into the joint (B) tightly.
E
D
IMPORTANT: After you connect the inner shaft to
the shaft of the outer pipe, pull on the flexible shaft
by hand to make sure the flexible shaft does not
come off.
4. Put the liner (E) straight and align the flexible shaft
(D) with the angular hole (G) on the side of the clutch
drum.
I
G
F
5. Install the liner (E) into the clutch housing (F). Make
sure that the hole on the end of the liner points
directly up.
6. When the hole (H) moves directly below the stopper
(I), you can hear a click which means the stopper
locks the liner.
1. If you cannot lock the liner (E) into position, pull it
out.
2. Turn the flexible shaft a small distance and try to
lock the liner (E) again.
B
H
E
11