Connecting A Vcr - Samsung LTM 1575W Owner's Instructions Manual

I
N S TA L L AT I O N

Connecting a VCR

These instructions assume that you have already connected your TV to an antenna or a cable
TV system (according to the instructions on pages 2.1-2.3). Skip step 1 if you have not yet
connected to an antenna or a cable system.
1
Unplug the cable or
antenna from the back
of the TV.
2
Connect the cable or
antenna to the ANTENNA
IN terminal on the back of
the VCR.
3
Connect a coaxial cable
between the ANTENNA
OUT terminal on the VCR
and the antenna terminal
on the TV.
A coaxial cable is usually included with a VCR. (If not, check your local electronics
store).
4
Connect a set of audio
cables between the
AUDIO OUT jacks on
the VCR and the
AUDIO jacks on the TV.
If you have a "mono" (non-stereo) VCR, use the Y-connector (not supplied) to hook up
to the left and right audio input jacks of the TV. If your VCR is stereo, you must connect
two cables.
5
Connect a video cable
between the VIDEO
OUT jack on the VCR
and the VIDEO jack on
the TV.
Follow the instructions in "Viewing a VCR or Camcorder Tape" to view your VCR tape.
2.5
C T : I
HAPTER WO NSTALLATION