Chamberlain CPT4 Owner's Manual

NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or
modifications of this receiver and/or transmitter are prohibited, except for
changing the code setting or replacing the battery. THERE ARE NO OTHER
USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation
is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
The Passport transmitter works with all LiftMaster Security✚
rolling code garage door openers.
When using the Passport transmitter with an access system or
gated entry, contact property manager.
If it is necessary to program a HomeLink
access system, contact property manager.
USING THE "LEARN" BUTTON
1. Press and release the "learn" button on
the motor unit. The learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that you
wish to operate your garage door.
3. Release the button when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks will
be heard.
To Erase All Codes From Motor Unit
Memory
To deactivate any unwanted remote, first
erase all codes:
Press and the hold "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each remote or keyless
entry you wish to use.
For more information, please visit www.devancocanada.com or call toll free at 855-931-3334
®
® transmitter for an
PROGRAMMING
9 1 9 1
7 3 7 3
5 5
KG KG
1 2 3
OR
KG KG
1 2
KG
1
2
K
KG
4-Channel Remote Control
WARNING
To prevent possible SERIOUS INJURY or DEATH from a moving
gate or garage door:
• ALWAYS keep remote controls out of reach of children. NEVER
permit children to operate, or play with remote control
transmitters.
• Activate gate or door ONLY when it can be seen clearly, is
properly adjusted, and there are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely
closed. NEVER permit anyone to cross path of moving gate or
door.
USING THE MULTI-FUNCTION DOOR CONTROL
1. Press and hold the button on the
hand-held remote* that you wish to
operate your garage door.
2. While holding the remote button,
press and hold the light button on the
Multi-Function Door Control.
3. Continue holding both buttons while you
press the push bar on the Multi-Function
Door Control (all three buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks will
be heard.
NOTE: The fourth button is
recommended for use with a
garage door opener and
cannot be used with an
access system. Use buttons
1 through 3 for the access
system or other garage door
openers.
Model CPT4
OWNER'S MANUAL
GARAGE DOOR
OPENER
4
3
ACCESS
2
SYSTEM
1
OR GARAGE
DOOR
OPENERS