Holland FW0070 Installation, Operation And Maintenance Manual page 13

4.4 Installation of Slide Stops
1. It is the responsibility of the installer to
insure that slide stops are installed properly
at all four corners of the slider plate.
2. Slide the bracket to the full rear position
and engage the plungers in the rack.
3. Locate rear stops under the curled
edge allowing clearance to the bracket
(approximately 1/8"). Clamp in place. This
should position the stops approximately
1/4" to 1/2" from the edge of the rear of
the plate (Figure 13 and 14).
4. Slide bracket ahead out of the way and
weld the stops in place as illustrated
(Figure 13 and 14). The welds should
be 5/16" fillet.
5. Slide the bracket to the full rear position and
check for clearance. Ensure the plungers on
the sliding bracket seat properly into the
rack with all teeth engaged.
6. Repaint as required.
4.5 Attachment of Air-Activated Slide
Release (If Required)
1. Mount the cab control valve in accordance
with the instructions provided. It should
be readily accessible to the driver, but
protected to prevent accidental activation.
2. Attach an air line, using appropriate
fittings to the "air" or "in" port of the
valve. Use an air source recommended by
the tractor manufacturer. Use fittings and
lines of suitable pressure rating.
3. Connect an air line between the "cyl" or
"out" port of the valve and the active side
of the air cylinder. A bulkhead fitting may
be placed at the front of the slide base
plate, if desired. Use fittings and lines of
suitable pressure rating and be sure line
is run so as not to interfere with any other
operation or component.
4. Check operation of the valve and cylinder
XL-FW482 Rev C · 2016-07-05 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
Installation Procedures
Figure 13
WELD THE FORWARD SIDE IN THE CENTER ONLY
TO AVOID INTERFERENCE WITH BRACKET.
1/4"- 1/2"
TYP.
5/16"
DIMENSIONS APPLY AFTER WELDING
Figure 14
TYP.
5/16"
1/8"
SLIDE STOP
13