Samsung HP-S6373 Owner's Instructions Manual page 61

3. Tighten the 6 screws in step 2 (plastic hanger + screw ) to the
rear holes of the product.
Plastic Hanger
How to Adjust Mounting Angle
Note: Please secure the mounting bracket on the wall surface after setting its angle at 0°
1. Secure the SET to the wall mount bracket.
(Please refer to the following instructions.)
2. Set the angle by pulling the upper end of the SET attached to
bracket in the direction of the arrow.
(Refer to the illustration on the right.)
3. The angle can be adjusted from 0° to 15° by ±2°.
Connecting External Devices to the PDP
Note: To connect external devices such as a DVD or a Home Theater System to the PDP, please refer to following instructions:
4. Remove safety pin (
corresponding bracket holes (
that it is firmly fixed to the bracket. Make sure to reinsert and tighten
the safety pin (
Hold onto the middle of the PDP to
adjust the angle (not the sides of the
PDP).
1. Be sure to remove the safety pins underneath the PDP.
Note: If the safety pins are not removed, the angle cannot be adjusted.
Any attempt to do so may cause damage to the PDP.
2. Hold onto the bottom of the PDP and pull forward fully as directed by the arrow as illustrated)
to adjust the angle. (0°~20° by 2°) Insert the Safety Pins to the front guide holes on both
sides as illustrated in figure @.
Note: Viewing the PDP after connecting the external devices Remove the Safety Pins
to adjust the angle to 0°, and then secure the Safety Pins again.
• For safety, be sure to secure the PDP using the safety pins. If the safety pins are not used,
the PDP may fall, causing serious injury.
English-61
#
) and insert the 4 product holders into the
! ). Then place the product (
# ) to securely hold the product to the bracket.
PDP
Wall Bracket Wall
@ ) so