Table of Contents
Advertisement
PDP
(Continued)
Problem
If the message "No Wireless Signal
or Please Check WIRELESS HOME
AV CENTER Power" appears:
This message is displayed when the
communication between the PDP and
the WIRELESS HOME AV CENTER
fails.
PDP set is turned on and the message
"No Wireless Signal or Please Check
WIRELESS HOME AV CENTER
Power" appears.
Cause 1: The WIRELESS HOME AV
CENTER is turned off.
Cause 2: The message still appears
despite the AV Center is on.
The picture continuously breaks up
and the message "No Wireless
Signal or Please Check WIRELESS
HOME AV CENTER Power" appears.
Cause: The product utilizes 5GHz
band for wireless signal transmission.
Other wireless devices may cause
picture noise or communication
errors. These problems may be
caused by Wireless PC networks or
wireless TV sets using the same band.
The message "Please check
resolution, AV Center can't support
720p/1080i component signal."
appears in the Component Mode.
Cause: AV Center only handles of
480i and 480p input. 720p and
1080i input cannot be processed.
Possible Solution
Check whether the WIRELESS HOME AV CENTER's Power
is turned ON. Check whether the Wireless LED on the
front panel is lit Green (If not, move the WIRELESS HOME
AV CENTER to a location where the Green LED lights up).
Solution 1: Turn on the PDP set and then turn on the AV
Center as they have separate power supplies.
Solution 2: Check if AV Receiver's LED at the top of PDP
set and the AV Center's wireless LED are ON and green.
If both are OFF, change both devices' positions so that
they face each other for better communication. If the
message appears again, turn both PDP and AV Center
OFF and then turn them back ON. If the problem persists,
contact the nearest service center.
Solution: During watching, another wireless device that
uses a single fixed frequency of the same band may
interfere and cause this problem. In this case, turn the
PDP and AV Center off and then back on. The WIRELESS
HOME AV CENTER has the function of frequency search
in the 5GHz band for clear data communication to avoid
signal interference.
Solution: Switch the input source to 480i or 480p.
79
Advertisement
Table of Contents
