Table of Contents
Advertisement
Storing Channels in Memory (Automatic Method)
First, select the correct antenna (Air and Cable).
1
See steps on previous page. Press the MENU button.
Press the
or
then press the ENTER button.
Press the
or
2
then press the ENTER button.
Quick way to access the Automatic Channel Setting:
Just press the "AUTO PROG." button on the remote control.
Press the
or
3
(Air, STD, HRC, and IRC). Select an option and then
press the ENTER button.
If you are connected to an antenna (Air), leave
"Air" displayed. If you are connected to a cable,
press the
or
system "STD", "HRC" or "IRC". (If you are not sure
which type of cable system you have, contact your
cable company).
Press the ENTER button.
4
The PDP will begin memorizing all of the available
channels. After all the available channels are stored,
the Auto program menu reappears. Press the MENU
button to stop.
Note
• Auto Program may take a few minutes to process.
36
button to select "Channel",
button to select "Auto Program",
button to select the correct signal
button to display the type of cable
Channel
TV
Select Antenna
: Air
Auto Program
Add/Delete
Fine Tune
Signal Strength
Move
Enter
TV
Channel
Select Antenna
: Air
Auto Program
Add/Delete
Fine Tune
Signal Strength
Move
Enter
TV
Auto Program
Air
STD
HRC
IRC
Move
Enter
Auto Program
It will take about several minutes.
Would you like to continue?
Start
Enter
Auto Program
Air Ch 23
Stop
Enter
√
√
√
√
√
Return
√
√
√
√
√
Return
Return
Return
Return
Advertisement
Table of Contents
