HP StorageWorks XP10000 User Manual page 74

Table 25 BC error codes (continued)
Error Description
Code
0801 The BC feature could not be used.
080B The request could not be accepted.
0810 The specified command cannot be accepted in this
status. (The command was rejected.)
0811 The specified command is treated as an NOP.
0812 The new pair could not be created because a path
group is set.
0813 The Pairsplit command was issued to a pair in the
PSUS status.
0814 The Paircreate command was issued to the pair in
the PAIR status.
0817 A Reserve volume cannot be set because a path
group is set.
0818 The Pairresync or Pairsplit-E command cannot be
issued because a path group is set.
081F Command Reject. P-VOL is used from HOST or by
CA.
0830 A pair cannot be created because the track format
is different.
0831 A pair cannot be created because a number of
slots is different.
0834 The emulation type of the specified P-VOL is not
supported by BC.
0835 The emulation type of the specified S-VOL is not
supported by BC.
0836 The pair cannot be created.
0840 Logical contradiction.
0841 Logical contradiction.
0842 Logical contradiction.
0848 Logical contradiction.
0849 Logical contradiction.
084A Logical contradiction.
084B Logical contradiction.
74 Business Copy XP (BC) for the XP10000/XP12000
Corrective Action
Ensure that the disk array has the correct
microcode level for BC, the disk array has BC
installed and enabled, and the Command View XP
management station or XP Remote Web Console
has BC installed and enabled.
Retry about one minute later.
Check the pair status, and ensure that the pair
status is correct for the command.
The specified command is treated as an NOP.
(NOP means the command can end without errors,
but executes nothing.)
Disconnect from host, or cancel Continuous Access
XP path.
On the Continuous Access XP main screen, confirm
the specified S-VOL is simplex, specify the
Pair by Force
option, and retry the operation.
The Pairsplit command cannot be issued because
the pair is already in PSUS status.
The Paircreate command cannot be issued because
the pair is already in PAIR status.
Disconnect volume to be reserved from host, or
delete Continuous Access XP path.
Unmount the S-VOL (offline from the host), or delete
Continuous Access XP path.
Disconnect from host, or cancel Continuous Access
XP path.
Ensure that the emulation type of the P-VOL and
S-VOL is the same.
Ensure that the capacity of the P-VOL and S-VOL is
the same.
Ensure that BC supports the emulation type of the
P-VOL.
Ensure that BC supports the emulation type of the
S-VOL.
The emulation type of the P-VOL and S-VOL is not
the same.
Call HP technical support for assistance.
Call HP technical support for assistance.
Call HP technical support for assistance.
Call HP technical support for assistance.
Call HP technical support for assistance.
Call HP technical support for assistance.
Call HP technical support for assistance.
Delete