Fisher & Paykel ACTIVESMART E372B Installation Manual page 22

Before you start using the Ice & Water or Automatic Ice function
Check your refrigerator is switched on.
● ●
Allow at least 2 hours for your refrigerator to cool before use.
● ●
Complete all the flushing steps detailed in this installation/user guide to ensure
● ●
optimum performance of your water filter.
For Ice & Water models only:
Press the water dispenser pad to dispense 2L of water.
1
There may be carbon residue dispensed together
● ●
with water. This is not harmful, and normal during
flushing process.
Wait for 2 minutes before dispensing again.
2
Dispense another 2L of water. Your water dispenser is
3
now ready for use.
Water will continue to drip from the dispenser for a
4
few more days after installation to clear remaining
trapped air in the dispenser. Check the drip tray
regularly and empty when required.
For Ice & Water and Automatic Ice models:
Turn the ice maker on by pressing the
1
The light above the
when the ice maker is on.
Press the ,
2
close the doors. The ice tray will empty the water into
the bin below. The ice tray will only empty after the
doors are closed.
Repeat step
3
2
collected during manufacture and transport.
Empty the water, dry the bin and return it correctly
4
(refer to diagrams 1 and 2 for placement of ice bins
for your refrigerator).
Once your ice maker is turned on the first bin of ice
5
may be discoloured, this is not harmful and normal
during the flushing process. Discard the first full bin
of ice made. Your ice maker is now ready for use.
– For Ice & Water models: the water filter will
reach optimum performance after two to three
full bins of ice.
– For Ice only models: the water filter will reach
optimum performance after four to five full
bins of ice.
20
INSTALLATION INSTRUCTIONS
button will be illuminated
and together for 4 seconds then
to remove dust in the ice tray
button.
Water dispenser
Diagram 1
Diagram 2
Ice storage bin and
scoop in correct position