Installation - Russound Acclaim 7 Series Installation Manual

InStAllAtIon

Installation
1. Remove the grille and baffle from the speaker, if applicable. Use the clamp
(dog-ear) to push the grille out from the back side.
2. Center the frame in the cutout. Tighten the screws equally until the clamps
secure the frame. Do not overtighten.
Cutout
Speaker Cable
Frame
Install Speaker Frame
8
As screws are tightened
clamp will rotate out and
snug against the drywall.
Screws
Russound In-wall LCR Loudspeaker Installation Manual
3. Connect the speaker wire to the speaker terminals:
• Leave about 1' (30.5 cm) of wire extending through the cutout.
• Pull the conductors apart so the last two inches are separated and
remove 1/2" (1.3 cm) of insulation from the end of each conductor.
• Twist the strands in each conductor into tight spirals.
• Attach the speaker wires to the red and black speaker terminals. Connect
the Positive (+) conductor to the Red terminal and the Negative (-)
conductor to the Black terminal. Make sure that no stray strands of wire
are touching the other conductor or terminal.
(+)
Insertion of speaker wire on back of speaker baffle
4. The speakers have a plug (the Russound Logo) that can be removed for
placement of an remote IR receiver (Russound 862 Eye). See detail below.
IR Receiver Installation
(-)
Baffle
IR Receiver
Plug