Baxi LUNA HT 1.850 Installers And Users Instructions page 7

3.5 SETTING THE DAILY PROGRAM FOR OPERATION IN CENTRAL HEATING AND DOMESTIC HOT WATER MODES
3.5.1 Setting the daily times for central heating mode operation
- Press either of the
a) press these keys until the display shows P11, referring to the program start time;
b) press the keys to set the time;
key; the display will show P12, referring to the program end time;
- press the
- repeat the operations described in points a and b until the third and last cycle is reached (program line P16);
- press the key to save and exit from the programming function.
3.5.2 Setting the daily times for domestic hot water mode operation
- As supplied by the factory the appliance is set up with the domestic hot water function always enabled and the domestic
hot water programming function disabled.
The instructions for enabling this program are given in chapter 15, which is addressed specifically to installers (parameter
H91).
If the program is enabled program lines from 31 to 36 must be set up as described in heading 3-5.1.
3.6 SETTING THE MINIMUM CENTRAL HEATING TEMPERATURE
- press either of the
- press these keys until the display shows P5, referring to the temperature to be set;
- press the keys to set the temperature required.
This operating mode is enabled when minimum temperature central heating mode "
central heating program does not require heat.
NOTE –
With the outdoor sensor probe connected, parameter P5 can be used to set the minimum room tempe-
rature in the premises to be heated.
INSTRUCTIONS PERTAINING TO THE USER
keys to access the programming function;
keys to access the programming function;
7
" is activated or when the daily
910.024.1 - EN (AUS)