Table of Contents
Advertisement
Installing a Module into the Remote 2C
To install a module into the Remote 2C, follow these steps:
1.
The modules are "hot swappable". You can leave the power on while inserting modules. (Note
that each module and Remote 2C will be reset when you insert a module). Remove the cover
plate on either slot:
2.
Insert a module with color handles that match the color swatch on the back of the Remote 2C:
HP J3138A AdvanceStack Internet Router Module
3.
Push the extractor handles down. Then tighten the two screws that hold it in place. Be careful
not to overtighten the screws.
Caution: Replace the cover plate over the slot using the two screws that hold it in place. Be
careful not to overtighten the screws. When using the Remote 2C without a module, the cover
plate must always be installed. This is required not only for safety, but also to ensure proper
cooling.
4.
On the front of the Remote 2C, remove the blank module label from the appropriate slot.
6
Loosen these screws
Advertisement
Table of Contents
