Sharp MX-3070N Handy Manual page 12

INITIAL SETUP
PRINT IMAGE POSITION & BK MAGNIFICATION:
Check Print Image Off Centre & Lead Edge position - Use Sim 50-10:-
 Inside dimension of the printed halftone must be 240±0.5mm.
 Lead edge void area 4.0 ± 1.0mm.
 Rear edge void area 2.0mm - 5.0mm.
 Front & Rear Void areas 2.0 ± 2.0mm.
IMAGE SKEW & COLOUR REGISTRATION
Sim 50-22
HALF TONE F/R EVENNESS & COLOUR CALIBRATION
Sim 61-13
Sim 61-11
Sim 46-74
IMAGE QUALITY CHECK [COPY & PRINT]
Check Image Quality (Copy Mode) – Density, Magnification, Lead Edge & Void.
Check Print Image Quality:
Sim 64-05
Sim 64-06
12
If NG, perform the following adjustments as required:-
Manual Adjustment:
Sim 50-10 BK MAG / Image Off Centre Adjustment (All Trays).
Sim 50-05 Printer Lead Edge & Void Adjust.
Automatic Adjustment:
Sim 50-28 BK MAG ADJ (Main Scan Mag).
SETUP/PRINT ADJ (Lead, Offset or All).
Colour Registration/Skew & OPC Drum Phase Adjustment:
Check/Adjust SKEW (CMY) so value is Close to 0 as possible (Result=OK).
F/R Evenness Correction Data
F/R Evenness Correction Adjustment.
Engine & Printer Colour Calibration:
If NG, perform the following adjustments as required:-
Sim 46-01 Copy Density Adjust. (Colour).
Sim 46-02 Copy Density Adjust. (B/W).
Sim 46-09 SPF Copy Density Adjust.
Manual Adjustment (Magnification, Lead Edge, Void, Off Centre etc):
Sim 48-01 Magnification Adjustment (OC & SPF).
Sim 50-01 Lead/Rear Edge, Loss & Void Adjust.
Sim 50-12 OC & SPF Off Centre Adjust.
Automatic Adjustment:
Sim 50-28 OC ADJUST (Lead, Offset & Mag).
SPF ADJ:(Lead, Offset & Sub scan).
PCL Density Test Page
PS Density Test Page
Clear.
Select FACTORY Mode.
SHARP