Cisco Nexus 7706 Hardware Installation Manual page 97

Installing or Replacing Modules, Fan Trays, and Power Supplies
1 Rotate the handle fully away from the front of the
module.
2 Align the bottom of the module to the module guides
in the slot.
c) Rotate the end of the handle away from the front of the module until it stops (see Callout 1 in the previous figure).
d) With one hand under the supervisor module and the other hand holding the module by its front, align the rear of the
module to the open supervisor slot.
e) Slide the module onto the guides inside the slot and push the module fully into the slot until you cannot push the
module further.
The front of the module should be about 1/4 inch (0.6 cm) in front of the chassis.
f) Rotate the handle to the front of the module (see Callout 1 in the following figure) until it clicks when it reaches the
front of the module.
The module should be fully inserted in the slot and the front of the module should be even with the fronts of all of
the other installed modules. The captive screw by the ejector button on the module should be aligned to a screw hole
on the chassis.
Figure 25: Securing a Supervisor Module to its Slot
1 Rotate the handle all the way to the front of the
module.
g) Screw in the captive screw to secure the module to the chassis (see Callout 2 in the previous figure). Tighten the
screw to 8 in-lb (0.9 N·m) of torque.
h) Verify that the supervisor module LEDs turn on and appear as follows:
• STATUS LED is green.
• SYSTEM LED is green.
• ACTIVE LED is amber or green.
For more information about the LED states for this module, see
i) Attach the management cable to the MGMT ETH port.
The MGMT ETH LED should be green. If not, see
LED states.
OL-31330-01
Installing or Replacing a Supervisor Module
3 Push the module all the way into the slot (until it stops
and the front is about 1/4 inch in front of the chassis).
2 Tighten the captive screw to 8 in-lb (0.9 N·m) of
torque.
Supervisor Module LEDs, on page
Supervisor Module LEDs, on page 160
Cisco Nexus 7706 Hardware Installation Guide
160.
for information about the
85