Table of Contents
Advertisement
O
Adjust Red Convergence
Adjust Blue Convergence
3.2
C
T
: O
HAPTER
HREE
PERATION
P E R AT I O N
4
While "Red" is highlighted (letters are
blue color), press the VOL+ button:
A crosshair pattern will appear on the
screen. If either a vertical or a
horizontal red line is visible, then the
convergence needs alignment.
5
If a horizontal red line is
visible, use CH▲ and CH▼ buttons
to move the line so that it is super-
imposed on the horizontal center-
line (i.e., make a single horizontal
line that is as white as possible.)
6
If a vertical red line is visible, use
the VOL + and VOL - buttons to
move the line so that it is superim-
posed on vertical-center line (i.e.,
make a single vertical line that is as
white as possible.)
7
At this point, the Red convergence
is correctly adjusted. Press MENU,
then press the CH▼ button once to
highlight the word "Blue."
8
While the word "Blue" is highlight-
ed, press the VOL+ button to adjust
the blue convergence. When the
crosshair pattern appears, use
+ -
CH▲ and CH▼ and VOL
converge the blue line (same
procedure as in steps 1~7, above).
9
After the blue convergence is
correctly adjusted, press MENU four times to exit all the menus.
Please, use remote control
R
Please, use remote control
R
Please, use remote control
R
Manual convergence
Red
Blue
±
Move
Ent.
Please, use remote control
B
to
Up/Down
±
L/R
Menu
Up/Down
±
L/R
Menu
Up/Down
±
L/R
Menu
SET UP
Menu
Up/Down
±
L/R
Menu
Advertisement
Table of Contents
