Brother 888-X64 Operation Manual page 27

• Attaching the extra spool pin
Put the extra spool pin in the hole on the top of the
machine. Put the second spool of thread onto the
extra spool pin.
<D
First spool
®
Second spool
• Twin needle threading
You should thread each needle separately .
0
e
e
~ Note
- - - - - - - - - -
Models equipped with a needle threader
e
You cannot use the needle threader to
thread the twin needle. Instead, thread the
twin needle by hand, from front to back.
Using the needle threader may damage the
machine.
Use the thread from the first spool to
thread the machine to the needle bar
thread guide.
The path for threading the mach ine to the
needle bar thread guide is the same as for
normall y threading the machine (for a single
needle). See page 18 for more details.
Thread the left needle from front to back.
Use the thread from the second spool to
thread the machine to the thread take-up
lever.
The path for threading the machine to the thread
take-up lever is the same as for normally
threading the machine (for a single needle). See
page 18 for more detai Is.
Thread the right needle from front to
back.
Do not pass the thread behind the needle bar
thread guide.
<D
Left needle thread passes through the needle
bar thread guide.
®
Right need fe thread passes in front of the needle
bar thread guide.
@
Needle bar thread guide
Attach zigzag foot
"J ".
For detai Is on changing the presser foot, refer
to "Changing the presser foot" on page 10 .
_AcAUTION
• When using the twin needle, be sure to
attach zigzag foot
"J ",
otherwise the
needle may break or the machine may be
damaged.
e
Turn on the machine.
,A.CAUTION
• Do not turn on the machine while
pressing down the foot controller. The
machine may start unexpectedly and
cause personal injury or damage to the
machine.
26