Threading The Machine; Winding The Bobbin - Brother 888-X64 Operation Manual

KNOWINC YOUR SEWING MACHINE
THREADING THE MACHINE
Winding the bobbin
AcAUTION
>
>
• We designed the bobbin that comes with this machine. If you use bobbins from other models,
the machine will not work properly. Only use the bobbin that comes with this machine or
bobbins of the same type (part code: SA156, SFB: XA5539-151). Using other bobbins may
cause damage to the machine. SA156 is Clas!> 15 type bobbin.
Actual size
o!. ' i ~:d<
t
:II
= :
==J
======
O
Pull the thread
in completely.
This model Other models
<D
Pre-tension disk
®
Bobbin winder shaft
@ Bobbin
0
Pull up the spool pin and put a spool of
thread on this pin.
A
While holding the thread from the spool
~
with your right hand, pass the thread
toward you, in the groove on the thread
guide. Then, pass the thread around the
pre-tension disk and pull the thread in
completely.
13
AcAUTION
• If the spool of thread is in the wrong
place, or is set incorrectly, the thread
may tangle on the spool pin.