Samsung SyncMaster 753Ms, 753v, 750s, 753s Owner's Manual page 42

Is the screen displaying only
The screen shows
one color as if looking at the
strange colors or
screen through a cellophane
just black and white.
paper?
Have the screen colors become
strange after running a program
or due to a crash between
applications?
Has the video card been set
properly?
Have you changed the video
The screen
suddenly has card or the driver?
become
unbalanced.
Have you adjusted the
resolution or frequency to the
monitor?
The screen can be unbalanced due to the cycle of the video card
signals. Readjust Position by referring to the OSD.
The screen is out of Have you adjusted the
focus or OSD resolution or frequency on the
cannot be adjusted. monitor?
The screen is Are there any magnetic
partially distorted. products such as an adapter,
speaker or a high voltage wire
near the monitor?
LED is blinking but Is the frequency properly
no images on the adjusted when checking the
screen. Display Timing on the menu?
Have the Windows colors been
There are only 16
set properly?
colors shown on the
screen. The screen
colors have
changed after
Has the video card been set
changing the video
properly?
card.
Have you installed the monitor
There is a message
driver?
that reads
"Unrecognized
monitor, Plug & Play
See the video card manual to
(VESA DDC) monitor
see if the Plug & Play (VESA
found".
DDC) function can be
supported.
For Multimedia model
Symptom
There is no sound.
The sound is too weak.
The sound is too sharp.
Check the signal cable connection.
Make sure the video card is fully
inserted in it's slot.
Reboot the computer.
Set the video card by referring to the
video card manual.
Adjust screen image position and
size using the OSD.
Adjust the resolution and frequency
at the video card.
(Refer to the
Adjust the resolution and frequency
of the video card.
(Refer to the
Enter the OSD and perform a
"Degauss".
Keep the monitor away from any
magnetic products.
Adjust the frequency properly by
referring to the video card manual
and the
(The maximum frequency per
resolution may differ from product to
product.)
For Windows ME/XP/2000:
Set the colors properly at the
Control Panel, Display, Settings.
Set the video card by referring to the
video card manual.
Install the monitor driver according to
the Driver Installation Instructions.
Install the monitor driver according to
the Driver Installation Instructions.
Solutions
Connect the stereo input jack of the monitor to the stereo
output jack of the computer thoroughly by using the voice
cable or adjust the volume.
Turn the volume up to MAX.
If the sound is still too weak even after setting the volume
on MAX, adjust the volume of the sound card or software
program in your computer.
Turn the volume slightly down.
If using an extensive microphone, adjust the volume while
Preset Timing Modes).
Preset Timing Modes).
Preset Timing Modes.