Honeywell Versaguard TG509F Installation Instructions

APPLICATION
The TG509F,G Versaguard™ Universal Thermostat
Guards cover and protect pneumatic wall thermostats
against tampering, damage and unauthorized adjustment
of thermostat settings. These mini-sized guards provide
coverage for smaller-sized pneumatic thermostats while
still allowing easy access for thermostat calibration. By
using an allen wrench (included), the thermostat cover can
be removed while the ring base remains in place. The
miniguards do not have wallplates, but can be used for
new and existing applications. See Table 1 for applications.
The guards are ideal for high-traffic areas such as offices,
lobbies, supermarkets, restaurants, clinics, and hospitals.
The TG509 includes a smoke-colored transparent or taupe
opaque polycarbonate cover and ring base, four anchors
and screws, and tumbler lock with two keys. Provision for
Honeywell logo (included) or OEM logo on guard cover.
Table 1. TG509 Thermostat Guard Applications.
Honeywell Johnson
TP970 T4002
TP971 T4100
TP972 T4506
TP973 T4756
TP974 T5002
T7660
TP9600
Series
INSTALLATION
When Installing this Product...
1. Read these instructions carefully. Failure to follow
them could damage the product.
2. Check the dimensions given in the instructions and
on the product to make sure the product is suitable
for your application.
®U.S. Registered Trademark
Copyright © 1997 Honeywell Inc. • All Rights Reserved
TG509F,G Versaguard™ Universal
Robert Shaw
Powers Original Uniline
TH192 T12 2211
TH193 T13 2212
TH194 T18 2214
TT184 T19 2216
T23 2218
T27
T32
T33
T34
T35
Thermostat Guards
INSTALLATION INSTRUCTIONS
Mounting
The Versaguard™ Universal Thermostat Guard can be
installed without removing the thermostat from the wall.
Mount Thermostat Guard
Place the ring base over the thermostat and/or
adaptor plate on the wall. Align the ring base with
the thermostat and level approximately.
Mark the four mounting holes.
NOTE: Do not use the four brass colored screws
for mounting. The brass colored screws
are intended only for models with
wallplates.
Mount the ring base on the wall using the four no. 6
sheet metal screws and the four anchors provided.
See Fig. 1.
9 0
8 0
7 0
6 0
9 0
8 0
7 0
6 0
RING BASE
MOUNTING SCREWS (4)
Fig. 1. Mount ring base.
Mount the guard cover by placing the hinged edge
of the guard cover on the ring base and swinging it
down (vertical mounting) or to the side (horizontal
mounting) until the guard cover is in place against
the ring base. See Fig. 2.
Lock the thermostat guard by turning the key
counterclockwise. See Fig. 3. The key can be
removed only in the locked position.
WALL
MOUNTING
HOLES (4)
THERMOSTAT
M15008
69-1008-1