Related Manuals for Danfoss Link SCM
Summary of Contents for Danfoss Link SCM
- Page 1 MAKING MODERN LIVING POSSIBLE Danfoss Link™ SCM Simple Communication Module Installation Guide Danfoss Heating Solutions...
-
Page 2: Table Of Contents
Getting started with Danfoss Link™ SCM . . . . . . . . . . . . . . . . . -
Page 3: Introduction
The Danfoss Link™ SCM (Simple Communication Module) is an electronic controller for turning the Away function ON/OFF in a Danfoss Link™ system . The Danfoss Link™ SCM is powered by 230 V~ . Installation The Danfoss Link™ wireless system’s transmission range is suf- ficient for most applications;... -
Page 4: Wiring
For further information, see the Danfoss Link™ CC installation guide . Note: If adding the Danfoss Link™ SCM to the Danfoss Link™ CC is unsuccessful, make sure the right Danfoss Link™ CC software version is applied. Correct version: 2.5.57 or higher. -
Page 5: Perform Network Test
2 seconds . If the test is satisfactory the green LED will flash and a message is displayed on the Danfoss Link™ CC . If the test fails the red LED will slow flash continuously . -
Page 6: Getting Started With Danfoss Link™ Scm
(OFF) . On the Danfoss Link™ MPB and the SCM the AWAY mode is indicated by a red LED . On the Danfoss Link™ CC the AWAY mode is indicated by the suitcase icon . After 10 minutes the AWAY mode screen will be replaced by the Standby screen for security reasons . -
Page 7: Technical Specifications
Installation Guide Danfoss Link™ SCM Technical specifications Operating voltage Danfoss Link™ SCM 8 - 32 VDC Operating voltage (Net adapter) 220 - 240 V~, 50 Hz Standby consumption 0 .9 W Ambient temperature 0˚ to +45˚C Transmission frequency 868 .42 MHz... - Page 8 Danfoss A/S Heating Solutions Haarupvaenget 11 8600 Silkeborg Denmark Phone: +45 7488 8000 Fax: +45 7488 8100 Email: heating.solutions@danfoss.com www.heating.danfoss.com 013R9559 VIFZT15X © Danfoss 01/2013...