3 × 3 Filter; Test Chart Output - Sony XCL-CG510 Technical Manual

Save LUT
When you change the settings, save them using the LUT-
SAVE command.
Command
LUT-SAVE
3 × 3 filter
A 3×3 area filter processing can be applied. The filter
processing with brightness of the central pixel and the
surrounding area, and the parameter of each pixel are
multiplied and added together. The result is the
brightness of the central pixel. Specify the coefficient in
the range of –8191 to 8191. 256 is regarded as ×1.
Depending on the parameter patterns, it can reduce
noise, adjust edge, and extract the outline.
Command Parameter
SP-FL 0
1
Command Parameter1 Parameter2
SP-FL-VAL 00
01
02
10
11
12
20
21
22
Setting
filter off
filter on
Setting
–
8191 to Parameter for the
8191 upper left pixel
–
8191 to Parameter for the
8191 upper pixel
–
8191 to Parameter for the
8191 upper right pixel
–
8191 to Parameter for the
8191 left pixel
–
8191 to Parameter for the
8191 central pixel
–
8191 to Parameter for the
8191 right pixel
–
8191 to Parameter for the
8191 lower left pixel
–
8191 to Parameter for the
8191 lower pixel
–
8191 to Parameter for the
8191 lower right pixel

Test Chart Output

For monochrome camera, monochrome chart can be set.
For color camera, monochrome chart or color chart can
be set.
Command Parameter
TESTCHART
Monochrome
Raw/Mono
0xF30
1
0xDC0
2
0xC80
3
0xA00
4
0x7A0
5
0x550
6
0x340
7
* 12 bit notation
28
Setting
0 Off
1 Monochrome chart
2 Color chart
Color
R G
0xFFF 0xFFF 0xFFF
0xFFF 0xFFF
0 0xFFF 0xFFF
0 0xFFF
0xFFF 0 0xFFF
0xFFF 0
0 0 0xFFF
B
0
0
0