Table of Contents
Advertisement
Appendix.
Saved data is stored in the following folder, this is just an example, so that you cannot copy and paste
following address. Address may vary dependent on OS version and setting structure.
If you copy these data to deferent PC, you can use same data with different PC.
[Windows7] 32bit Japanese OS
C:\Users\"Username"\AppData\LocalLow\Microsoft\Silverlight\is\sku5do21.vvf
\ew3v0fpq.aka\1\s\cn0h5yuupoeupbc13vuem1kaxfgf41gidh3tdd3ujvojpayk4baaaeca\f
[Windows XP] Japanese OS
C:\Documents and Settings\"username"\Local Settings\ApplicationData\Microsoft\Silverlight\is
\ixo4f34m. u1d\tuwx4ud4.5ut\1\s
\cn0h5yuupoeupbc13vuem1kaxfgf41gidh3tdd3ujvojpayk4baaaeca\f
Once you saved in local PC, there are7 different files created as one saved system.
ie) 2218031004570_demosample_CORIOmasterInputs.xml
System Serial#* System Name
Files in one system
Canvases.xml
Inputs.xml
Layouts.xml
Outputs.xml
Preset.xml
System.xml
Windows.xml
The system refers to the system serial#, so that if you swap the product, need to change system serial#
as well in order to resume the data into new product.
If your system configuration is different, you may not log in the ET-MWP100G.
Here is the step.
*System serial# is different from Product serial#, so that you cannot see the number unless
you log-in ET-MWP100G.
7 different filename
1) Check system serial# of new unit
You can check system serial# in "Settings" >"General" tab.
2) Change system serial# from old to new.
ie) old
2218031004570_demosample_CORIOmasterInputs.xml
new
2218031005200_demosample_CORIOmasterInputs.xml
3) Open "...system.xml" file.
Change system serial# and overwrite the file.
4) Then, you can resume the system when you log-in a new unit.
12
Advertisement
Table of Contents
