Mercedes-Benz GLE 2018 Supplement To The Owner's Manual page 10

8
Changes as compared to the Owner's Manual
& WARNING
Mercedes-Benz Australia/Pacific Pty Ltd
wish to advise that the child restraint upper
anchor fitting installed to the rear seating
position of this vehicle MUST only be used
with NEW child restraint systems complying
with AUSTRALIAN STANDARD AS/NZS
1754-2000, 2004, 2010 or 2013 versions.
THE UPPER ANCHOR FITTINGS ARE NOT
COMPATIBLE WITH OLDER CHILD
RESTRAINT SYSTEMS.
Upper Anchor Fitting
A-Class
The upper anchorages are located on the rear
side of the rear seat backrests.
Seats with adjustable head restraints:
Move head restraint upwards.
#
For an upper anchorage strap with one belt
#
strap, route the upper anchorage strap under
the head restraint between the two head
restraint bars.
For an upper anchorage strap with two belt
#
straps, route the upper anchorage strap on
the left and right past the side of the head
restraint.
Move head restraint back down again slightly
#
if required. Make sure that you do not inter‐
fere with the correct routing of upper anchor‐
age strap.
Seats without adjustable head restraints:
For an upper anchorage strap with one belt
#
strap, route the upper anchorage strap cen‐
trally over the head restraint
For an upper anchorage strap with two belt
#
straps, route the upper anchorage strap on
the left and right past the side of the head
restraint.
All seats:
Securely fasten the attachment clip which is
#
part of the upper anchorage strap, to the
upper anchor fitting 1.
Tension upper anchorage strap. Comply with
#
the manufacturer's installation instructions
when doing so.
Ensure that the upper anchorage strap is not
#
twisted.
B-Class
The upper anchorages are located on the rear
side of the rear seat backrests.