Xerox Phaser 6510 User Manual page 142

Troubleshooting
Symptom
• Vertical black or color streaks or
multiple colored streaks or
lines.
• Streaks in only one color.
Partial blanks, creased paper, or
blotted printing.
Vertical blanks appear.
142 Xerox ® Phaser ®
User Guide
Probable Causes
The toner cartridges are not
Xerox ® toner cartridges.
Debris in the printer is dragging
against the toner before it is
fused.
There is a problem with the toner
cartridge for that color.
The paper is damp.
The paper is outside the
recommended specification range.
The printer is worn or damaged.
The toner cartridges are not
Xerox ® toner cartridges.
The paper is impeded in the paper
path.
Condensation inside the printer
causes partial blanks or creased
paper.
The LED lenses are blocked.
6510 Printer
Solutions
them if necessary. For details, refer
to Consumables.
Ensure that the toner cartridges
meet specifications and replace
them if necessary. For details, refer
to Consumables.
Remove any debris or paper scraps
from the paper path under the
rear cover.
Check the toner cartridge for
damage and replace if necessary.
For assistance, go to the Xerox
Support website at www.xerox.
com/office/6510support.
Replace the paper.
Replace the paper with a
recommended size and type. For
details, refer to Supported
For assistance, go to the Xerox
Support website at www.xerox.
com/office/6510support.
Verify that the toner cartridges
meet specifications and replace if
necessary. For details, refer to
Consumables.
• Remove any paper or debris
from the paper path.
• Ensure that the trays are
pushed in all the way.
• Ensure that the rear cover is
closed and locked.
Power on the printer and leave it
on for at least one hour to get rid
of the condensation. For
assistance, go to the Xerox
Support website at www.xerox.
com/office/6510support.
Clean the LED lenses. For details,
refer to Cleaning the LED
®
Paper.
®
®
Lenses.