Samsung VP-M102 Owner's Instruction Manual page 61

Display Informs that
Not enough free space Not enough free space for saving files
Corrupted file The file is corrupted
Paper error The paper is insufficient.
Printer error The paper is caught in the printer.
Ink error Ink is low.
Wrong error The file is wrong.
USB transfer error The error is occurred while transferring data.
Low battery Battery is low.
Holding the key The hold key is locked.
Card error The memory card is corrupted.
Not formatted Format the memory card.
Write error Failed to write.
Read error Failed to read.
Not supported format The format is not supported.
Write protected Memory Stick is protected to write.
MPEG decoding error The video file is corrupted.
If these instructions do not solve your problem, contact your nearest Samsung dealer or authorized service centre/personnel.
Symptom Possible Causes
No power is supplied The power is not connected properly
The battery is dead
The battery is too cold
DATE/TIME is wrong The DATE/TIME is not set
Focus is set to manual mode
Focus does not adjust automatically Recording was done in a dark place
Lens is covered with condensation
The Memory Stick will not
Memory stick is in wrong position
load properly Something fills in the Memory Stick slot
Action
Check the space of internal memory or the Memory Stick.
Delete the corrupted file.
Check the paper in the printer. If there is no paper, insert paper.
Check that paper is caught in the printer. Pull out the caught paper.
Check if the ink or toner is low.
Check that the file is JPEG.
Disconnect the USB cable and connect it again.
Charge the battery pack or connect the AC Adapter.
Unlock the hold key and operate the CAM.
Format the Memory Stick or replace it with new one.
Format the Memory Stick.
Check the memory space or format the memory.
Delete the file.
The AVI or JPEG file that is not supported. Check the supported file
on the page 29.
Unlock the Memory Stick.
Delete the corrupted file.
Measure
Connect the AC adapter properly, page 23
Replace the dead battery pack
Warm up the battery or move to warmer place
Set the DATE/TIME, pages 88~89
Set focus to AUTO
Use strobe or lit the place
Clear the lens and check the focus
Insert the Memory Stick properly, page 33
Clear the Memory Stick slot
Symptom Possible Causes
Colour balance of picture is not natural White balance adjustment is required
Digital zoom does not work Digital special effect is applied
Files stored in the Memory Stick Memory Stick is protected
cannot be deleted File is locked
Images on the LCD monitor appear Ambient is too bright
dark Ambient temperature is too low
Rear of the LCD monitor is hot Prolonged use of LCD monitor
Play, rewind and fast forwarding do The Photo Mode is selected
not work
Memory Stick cannot be played The Video Mode is selected
back (Photo mode)
No picture is taken when is fully Not enough free memory space is
pressed remained
Memory card is formatted by different
devices
Built-in Light will fire Light is forced to cancel
Light is not available for recording
Cannot Record a video The Photo Mode is selected
Measure
Set proper white balance, page 65
Turn off the digital special effects, page 51
Remove the protection tab of Memory Stick
Remove the lock on the file, page 82
Adjust the brightness and angle of LCD
Low temperatures might produce a dark LCD display
This is not a malfunction
Close the LCD monitor to turn if off,
or turn your device off to cool down
Select Video Mode Play
Select Photo Mode and select View
Delete files from the Memory Stick
Format the Memory Stick on the CAM
Select different Light mode, page 62
Select Video Mode