Table of Contents
Advertisement
Important requirements to activate Reservation Mode
The transmission must be in the NEUTRAL position.
The vehicle windows must be rolled up.
Do not set the reservation mode with people in the vehicle.
Do not auto-start the vehicle with people in the it.
Activating Reservation Mode
(Manual Transmission only)
Step1 :
After arriving at your destination, and BEFORE TURNING
YOUR ENGINE OFF, place the transmission in the Neutral position.
Step2 :
Activate the parking brake.
Step3 :
Remove your foot from the foot brake.
Step4 :
Remove the key from the ignition, and the engine will remain running.
Step5 :
Exit the vehicle and close the door within two minutes after
activating the parking brake. The engine will shut off and reservation
mode for the remote starter is now complete.
Your vehicle is now ready for auto-starting. However, the reservation mode will
be cancelled if the door is opened or the Young Shin Electronics, Inc. system is put
in Valet mode after the reservation has been set. Once cancelled, you will have to
start the vehicle with the manual key and repeat the above 5 steps if you want to
restore reservation mode.
Important!
When the vehicle shuts off after reservation mode, the
Young Shin Electronics, Inc system will lock/arm the vehicle. Take care to not
lock your keys inside.
Important!
If you try to auto-start the vehicle when reservation mode
has not been set, the auto-start feature will not work.
When you press the auto-start button, the remote will beep three times. The car
parking lights will flash three times, pause, then flash seven times.
Page 12
Canceling Reservation Mode
If you do not want to set reservation mode, shut off the engine before you exit the
vehicle. The engine will shut off for the following reasons:
- You did not activate the parking brake or pressed the foot brake when you
turned the manual key to the off position.
- You released the parking brake while the engine was running.
- You entered Valet Mode after the Reservation Mode has been completed.
Trunk Release
Press Button III for 2 seconds in order to unlock and release your trunk.
Note that, the trunk release function will not only release the trunk, but will unlock
all the doors as well.
Query Function
Query Function allows the you to visually monitor the status of your car by
looking at the remote-pager GLO LCD icons. Press button IV for a 1/2
second to activate the Query Function.
Panic Mode
Press button IV for 2 seconds to enter Panic Mode. In this mode, the car will arm,
if not armed already, and the siren/horn will activate and the parking lights will flash.
In order to disengage Panic Mode, press button I for a 1/2 second.
Then, press button I for a 1/2 second to unlock/disarm your vehicle.
If Anti-Jacking option has been programmed (ask your dealer if you
would like to have this option) and the Ignition-Kill has been installed ,
the Panic Mode works as Anti-Jacking if the key is in the ignition.
If Anti-Jacking mode is activated while key is in the ignition,
a)The siren will go off for 1.5 minutes, and b) Ignition-Kill will be activated
after the first 30 seconds. This is to give a 30 second warning to the hijacker,
then to disconnect the ignition to stop the vehicle.
Page 13
Advertisement
Table of Contents
