Table of Contents
Advertisement
Dual Stage Shock Sensor
Press Buttons (I+III) for 2 seconds to activate or deactivate the dual stage shock
sensor. The dual stage shock sensor will activate in 30 seconds after the CompuStar
alarm mode is armed. When the dual shock sensor is engaged, the remote-pager
will be alerted by the following triggers:
-
Light impact to your vehicle will activate the first stage of the shock sensor
and the car siren will chirp 4 times in addition to the parking lights
flashing 4 times. The remote-pager unit will be notified audibly and the
hammer icon will flash on the LCD
- Heavy impact to your vehicle will activate the second stage of the shock
sensor and the car siren will sound for 30 to 60 seconds and the parking
lights will flash for 30 to 60 seconds. The remote-pager will be notified
audibly and a hammer icon will flash ion the LCD.
I
Press Button
for a 1/2 second to turn off the the alarm if it has been
triggered by the second stage of the shock sensor.
Auto-Start Function
Press button II for 2 seconds to auto-start an automatic transmission engine.
Remember, that a manual key in the ignition is required to drive the car.
For manual transmission vehicles, please use reservation mode.
Press button II for 2 seconds in order to turn off an auto-started car.
The engine will run 15 or 25 minutes (25 or 45 min for diesel) depending on preset
options at the time of installation and then shut off.
Shows the amount of run-time left in the remote
start mode.
Anti-Grind
The anti-grind circuit (an optional feature provided by your installer) prevents you
from engaging the starter on a remote-started vehicle.
Page 10
Diagnosing problems with Auto-Start
If there is a problem in auto-starting your vehicle,the Young Shin Electronics,Inc.
system will do one of two things; if it fails for any of the reasons listed in the table
below, it will flash the parkinglights three times then flash the error number.
Otherwise, it will attempt to start the vehicle three times. If, after three times, the
vehicle will not start or stay running, the Young Shin Electronics,Inc. system will shut
down. In either case, please see your installer to resolve the situation.
Error Number
(# of times parking lights flash)
1
2
3
4
5
6
7
Continuation Mode:(Automatic transmission only)
While your vehicle is running with your key, press button II for 2 seconds,
you are now in the continuation mode. Your engine will continue running for the
preset time even if you take your key out the ignition.
For a quick stop when you don't want to restart the vehicle.
Example:
Reservation Mode
In order to auto-start your manual transmission vehicle, you must first set the
Young Shin Electronics, Inc system to Reservation Mode before leaving your vehicle.
The purpose of Reservation Mode is to leave the transmission gear in the neutral
position when you leave your vehicle. Reservation mode is intended for use on
MANUAL TRANSMISSIONS ONLY and NOT FOR AUTOMATIC TRANSMISSIONS.
Reservation Mode must be engaged each and every time you leave your manual
transmission vehicle in order to auto-start it.
Note :
The system is not recommended for vehicles with removable tops.
Page 11
Error Reason
Engine On
Key On
Door Open
Trunk Open
Brake On
Hood Open
Reservation Off (Manual Transmission Only)
(manual transmission only)
Advertisement
Table of Contents
