Bb.seat Pan; Cc.carriage - Sunrise Medical Quickie Iris Owner's Manual

ENG LI S H
4) Growable Strut Tube Width Adjustment (Roller assembly)
a. Remove the hardware (G), (H), and (I) from the strut tubes.
b. Adjust all three tubes an equal distance, and re-tighten the hardware to a torque setting
of 150 in-lbs after adjusting the strut tubes.
NOTE– Use a torque setting of 200 in.-lbs. when tightening hardware (J)f
48 49
BB. SEAT PAN
The seat pan of the IRIS is designed to accommodate depth adjustment.
Depth adjustment
a. Loosen and remove all bolts (A).
b. Adjust the seat pan to the desired depth.
c. Replace and tighten all bolts.
NOTE– Use the holes that place the bolts as far away from each other as possible.
Width adjustment
a. Loosen and remove all bolts (B).
b. Adjust chair to the desired width.
c. Replace and tighten all bolts.
50 51
CC. CARRIAGE
The carriage of the IRIS can be adjusted to a preset the range of tilt.
1. Adjustment
a. Loosen and remove bolts C & D.
b. Set the carriage at desired range setting using the proper holes.
c. Replace and tighten all bolts.
IMPORTANT NOTE– The adjustment on each side of the chair should be exactly equal.
NOTE– Use a torque setting of 120 in.-lbs. When setting-up carriage.
2. Range and setting– 55°
a. -5° to 50°– use holes E & H
b. 0° to 55°– use holes E & G
c. 5° to 60°– use holes F & G
3. Range and setting– 40°
a. -5° to 35°– use holes E & H
b. 0° to 40°– use holes E & G
c. 5° to 45°– use holes F & G
NOTE– It is highly recommended to replace both rollers within each carriage assembly at the same time.
Do not use lubricants anywhere on the assembly.
IX. DEALER SERVICE & ADJUSTMENT
47
31
G
H
E
F
47
I
J
48
49
50
51
G
H
MK-100151 Rev. B