Troubleshooting; Troubleshooting The Tractor - Simplicity 1693074 Operator's Manual

Troubleshooting

This section of the manual provides troubleshooting and
repair instructions for the more common and easily cor-
rected problems. For other problems, it is recommended
that you contact your dealer.
Locate the problem that best describes the trouble that
you have encountered. Check the possible causes one
at a time, in the order that they are listed.

TROUBLESHOOTING THE TRACTOR

SYMPTOM
Engine will not turnover or start.
Engine starts hard or runs poorly.
Engine knocks.
Excessive oil consumption.
Engine exhaust is black.
Engine runs, but tractor will
not drive.
PROBLEM
1. Gear Selector not in
neutral-start position.
2. PTO (electric clutch) switch
in ON position.
3. Out of fuel.
4. Engine flooded.
5. Circuit breaker tripped.
6. Battery terminals require
cleaning.
7. Battery discharged or dead.
8. Wiring loose or broken.
9. Solenoid or starter motor faulty.
10. Safety interlock switch or
module faulty.
11. Spark plug(s) faulty, fouled
or incorrectly gapped.
12. Water in fuel.
13. Gas is old or stale.
14. Clutch/Brake pedal not depressed.
1. Fuel mixture too rich.
2. Spark plug faulty, fouled, or
incorrectly gapped.
1. Low oil level.
2. Using wrong grade oil.
1. Engine running too hot.
2. Using wrong weight oil.
3. Too much oil in crankcase.
1. Dirty air filter.
2. Engine throttle control
is in choke position.
1. Gear Selector in neutral.
2. Transmission release lever
in "push" position.
(Hydro models only)
3. Belt is broken.
4. Drive belt slips.
5. Brake is not fully released.
18
WARNING
Never attempt to perform repairs while the engine
is running.
Always turn the engine off and remove the key.
FAILURE TO COMPLY WITH THIS, AND OTHER,
SAFETY REQUIREMENTS CAN RESULT IN SERI-
OUS PERSONAL INJURY.
SOLUTION
1. Shift into neutral.
2. Place in OFF position.
3. If engine is hot, allow it to cool, then refill
the fuel tank.
4. Move throttle control out of CHOKE position.
5. Wait one minute for automatic reset, replace if
defective.
6. See Maintenance Section.
7. Recharge or replace.
8. Visually check wiring & replace broken or frayed
wires. Tighten loose connections.
9. Repair or replace. See authorized dealer .
10. Replace as needed. See authorized
service dealer.
11. Clean and gap or replace. See engine manual.
12. Drain fuel & refill with fresh fuel.
13. Drain fuel & replace with fresh fuel.
14. Depress pedal.
1. Clean air filter. Check choke adjustment
(engine speed control).
2. Clean and gap or replace. See engine manual.
1. Check/add oil as required.
2. See engine manual.
1. Clean engine fins, blower screen and
air cleaner.
2. See engine manual.
3. Drain excess oil.
1. Replace air filter. See maintenance section.
2. Change engine speed control position.
1. Shift in forward or reverse.
2. Move into drive position.
3. See Drive Belt Replacement.
4. See problem and cause below.
5. See authorized service dealer