Sony MKS-8010A Operation Manual page 12

Caution
For information about installing, contact your Sony
service representative.
g U (signal ground) terminal
Connect to the system ground.
h EDITOR PANEL connector (D-sub 15-pin, RS-
422A)
This connector is reserved for future system expansion.
i PERIPH (peripheral) connector (RJ-45)
Connect to the DCU-8000 Device Control Unit Pack with
a cross cable to enable communications with the DCU-
8000.
Note
An Ethernet switch is required to connect two or more
DCU-8000 Device Control Units.
j DEVICE connector (USB Type A)
Connect to the HOST connector of the main panel, AUX
panel or the MKS-8076 Memory Card/USB Adaptor.
k DATA connector (RJ-45)
Connect to an Ethernet switch.*
The MVS-8000A/8000ASF Switcher Processor, the
MVE-8000A DME Processor and other devices can be
connected in the same way to the Ethernet switch to form
a network for exchange of signals between the devices.
This network is used primarily for exchange of various
types of data (key frame effects, snapshots, etc.) and still
pictures of frame memory.
* Ethernet is a trademark of XEROX Corporation.
For information about Ethernet switches that can be used in an MVS
system, contact your Sony service representative.
For detailed information about setting up the Ethernet
switch, refer to the documentation supplied with the
Ethernet switch.
l MAIN PANEL connector (D-sub 50-pin,
special interface)
Connect to the SCU connector of the main panel.
12
Location and Function of Parts
m CTRL (control) connector (RJ-45)
Connect to an Ethernet switch.
The MVS-8000A/8000ASF Switcher Processor, the
MVE-8000A DME Processor and other devices are
connected in the same way to the Ethernet switch to form
a network for exchange of signals between the devices.
This network is used primarily to control the various
devices from the center control panel.
n EXT (extension) DISPLAY connector
(high-density D-sub 15-pin, analog RGB)
This connector is reserved for future system expansion.
o MENU PANEL connector (D-sub 50-pin,
special interface)
Connect to the menu panel.
Caution
• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to the
following ports.
- PERIPH (peripheral) connector
- DATA connector
- CTRL (control) connector
Follow the instructions for the above ports.
• When you connect the LAN cable of the unit to
peripheral device, use a shielded-type cable to prevent
malfunction due to radiation noise.