PERATING ONDITIONER Cooling Your Room ... Airing Your Room ... Removing Excess Humidity ... 10 Adjusting the Air Flow Direction Horizontally ... 11 Adjusting the Air Flow Direction Vertically ... 11 ROGRAMMING ONDITIONER Setting the On Timer ... 12 Setting the Off Timer ... 13 Setting the Sleep Timer ...
The Power Plug contains a Reset button that will automatically shut down the air conditioner in the event of a power surge. To restart the unit, press the Reset button and the unit will return to normal operation in 2-3 minutes.
Batteries may be completely discharged after 12 months, even if they have not been used. Push the battery cover on the rear of the remote control with your thumb in the direction of the arrow and remove it. Insert the two batteries, taking care to respect the polarities : + on the battery with + on the remote control.
Remote Control Control Panel You must select the Cool mode if you wish to lower the temperature in your room. You can also set the Fan Speed. The Air Conditioner starts up in Cool mode. It will begin to cool after three minutes the Air Conditioner starts cooling is displayed.
If you want to provide air circulation without cooling, you can use the Fan mode. If you wish to evacuate stale air outside, push the ventilation lever on the front of the unit to the right and the open position (...
Removing Excess Humidity Remote Control Control Panel If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. If necessary, press the (On/Off) button. The Air Conditioner starts up in Cool mode.
I nner A ir F low B lades on the unit. Adjust the Inner Air Flow Blades to the desired position by sliding them side to side. The O uter A ir F low B lades can be adjusted to control the vertical air flow direction.
Remote control The Air Conditioner will operate with the previously selected settings. If you select the Energy Saving mode while in Sleep mode, the Sleep mode will be cancelled and the air conditioner will start in the Energy Saving mode.
The fan will continue to run for a short time after the compressor cycles off. If you would like the Air Conditioner to run in Dry mode, do not press button. You cannot use the Dry mode while in the Energy E.Saver...
Be sure to clean the Air Filter periodically to keep the Air Conditioner operating at optimum level. When cleaning the Air Conditioner,turn it off and pull out the power plug. Front Grille Front Grille Air Filter Air Filter Air Filter...
Design and specifications are subject to change without notice. MODEL Unit of Measure AW25ECB7 Net Dimensions: 26 X 17.72 X 28.15 Inch (mm) (Width x Height x Depth) (660 X 450 X 715) Voltage Volt 208-230 Hertz Rated Amps 12.8/12.0...
Do not, under any circumstances, cut or remove the third grounding prong from the power cord. We recommend that you do not use an extension cord or an adapter plug with this appliance. Do not change the plug on the power cord of this appliance.
Page 23
Air Conditioner Cabinet 30 in. to 40 in. 18.5 in. (76.2cm to 101.6cm) (47cm)
Page 27
12 Install the V-supports. 12-1 Thread a Type C leveling bolt about 1/2 of the way into the outer face of the shortest angle of each Type C V-support. 12-2 Install each V-support to the Cabinet with four Type B screws.