Selecting Energy Saving Mode
Remote Control
Control Panel
Power Failure
12
E-
If you wish to save energy when using your air conditioner,
select the energy saving mode with the Energy Saver button.
1
To select the energy saving mode, press the Energy Saver button on the
remote control or unit one or more times until the Energy Saver indicator
lights up.
Result:
The fan and compressor cycle on and off together.
The fan will continue to run for a short time after the
compressor cycles off.
If you would like the air conditioner to run in Fan mode, do not press
the Energy Saver button. You cannot use the Fan mode in the energy
saving mode.
2
To stop the energy saving mode, press the Energy Saver button on the
remote control or unit again.
Result:
The fan runs at all times, while the compressor cycles on and off.
If a power failure occurs when the air conditioner is operating, the unit is
switched off. When the power comes back on, wait five minutes before
pressing
(On/Off) to restart the unit.