Canon WUX450 User Commands page 15

Environment
This defines the environments that support the command (power supply state, input signal state).
The command is executable when the projector is in the mode indicated by "○" in the table of
corresponding command description page.
Power mode restriction
LAN *1
SL0 SL1 SL3 ON
*2 *3 *4 *5
*1 Power mode restriction/LAN
*2 SL0
*3 SL1
*4 SL3
*5 ON
*6 Power / RS-232C
*7 ST
*8 Input
Remarks
Remarks about the command is inserted when necessary.
Example
Specific example of the command is inserted when necessary.
WUX450 / WX520 / WUX400ST / WX450ST User Commands
RS-232C *6
ST ON D-RGB A-RGB COMP
*7 *5 *8 *8
Indicates whether the command coming through LAN is executable.
Standby mode, and the network function is turned off.
When the network function is turned off, the command is not executable if
coming from LAN, in which case, this should never be "O".
"O" if enabled in a power ON state.
Standby mode, and the network standby setting is set to "Eco."
Normal projection status
Indicates whether the command coming through RS-232C is executable.
Standby mode (includes SL0, SL1 and SL3 altogether, regardless of the
network setting).
Indicates whether the command that is depending on input signal is
executable while the power is on.
- 12 -
Input *8
HDMI LAN USB
*8 *8 *8 *8
None
*8