Entering A Password; Correcting A Password - Siemens SIMATIC TD 200 User Manual

Operating the TD 200

Entering a Password

To enter a password, perform the following steps.
Key
1.
2.
ENTER
Repeat this process for all eight password characters. For passwords with fewer
than eight characters, use blank spaces (the default character) by pressing
ENTER for the unused (remaining) characters. After the eighth character is
entered, the TD 200 attempts to legitimize the communication link to the CPU. If
the password is incorrect, the TD 200 displays the message shown in Figure 3-3.
Figure 3-3 Incorrect Password Display

Correcting a Password

Press ESC and repeat the steps for entering a password.
3-10
Action
The TD 200 scrolls through the
possible characters for the password.
Press when the correct
ENTER
character is found for the current
password character location. The
cursor then moves to the next
character location.
SIEMENS
Display
PASSWORD REQUIRED
PASSWORD ********
PASSWORD REQUIRED
PASSWORD ********
TD 200
SIMATIC TD 200 Operator Interface
C79000-G7076-C272-01