Connecting To The Resolv120A Subwoofer - Samson Resolv 50a Owner's Manual

Two-way active studio reference monitor

Owner's manual (50 pages)

Table of Contents

Available languages

RESOLV 50a with Mono Sub

Adding a subwoofer (and extended low frequency response) to your RESOLV 50a system is easy using the RESOLV 50a's

LINE LEVEL inputs. Below is a typical system set-up using the RESOLV 120a with a mixer and a pair of RESOLV 50a satellite

speakers. For a detailed wiring diagram, see the section "RESOLV 50a Connections" on page 12. Follow the steps in the

diagram below to set up your system:

FROM MIXER

•

Lower your mixer's master outputs to all the way off.

•

Connect the mixer's Left output to the RESOLV 120's LEFT PREAMP LEVEL INPUT and the mixer's Right output to

the RESOLV 120's RIGHT PREAMP LEVEL INPUT. Now connect the RESOLV 120's LEFT PREAMP LEVEL OUTPUT to

the input of the left RESOLV 50a, and the RESOLV 120's RIGHT PREAMP LEVEL OUTPUT to the input of the right

RESOLV 50a.

•

Run an audio signal (like some music from a CD) through your mixer and raise the level to a comfortable

listening level.

•

Now adjust the SWEEP control to the desired frequency. A good place to start is about 70 Hz. You can also use

your ears by adjusting the SWEEP control to the frequency that sounds good to you.