Omron V680-HS63 User Manual page 29

Attaching the End Plates
To mount an End Plate easily, first hook the bottom of the End Plate and then
hook the top on the DIN Track, pull the End Plate downwards and tighten the
screw.
Recommended tightening torque: 1.2 N·m.
■ Mounting Interval
The V680-HAM42-FRT FL Remote ID Units will generate heat if they are mounted side-by-side. Leave
space between Units of at least 10 mm.
10 mm min.
V680-HAM42-FRT
OMRON
DEV TR 8 7 6 5
RMT NORM/ERR 4 3 2 1
NODE No. MODE
0 0 0
X10 1 X10 0
OFF
SOURCE : 24VDC 0.3A FSM RFID
OMRON Corporation MADE IN JAPAN
End Plate Spacer
Use at least 2 OMRON DIN Track Spacers. (Each Spacer is 5 mm wide.)
Spacer
PFP-S
10 mm min.
V680-HAM42-FRT V680-HAM42-FRT
OMRON OMRON
DEV TR 8 7 6 5 DEV TR 8 7 6 5
RMT NORM/ERR 4 3 2 1 RMT NORM/ERR 4 3 2 1
NODE No. MODE NODE No. MODE
0 0 0 0 0 0
X10 1 X10 0 X10 1 X10 0
OFF OFF
SOURCE : 24VDC 0.3A FSM RFID SOURCE : 24VDC 0.3A FSM RFID
OMRON Corporation MADE IN JAPAN OMRON Corporation MADE IN JAPAN
End Plate
Spacer
Installation, Connections, and Wiring
SECTION 2
RFID System
27
User's Manual